Aga-ranges 6-4 Series Uživatelský manuál Strana 1

AGA SIX-FOUR SERIES - DC6 (FFD)(NATURAL GAS AND PROPANE GAS)OWNERS MANUAL03/08 EINS 514735PLEASE READ THESE INSTRUCTIONS BEFORE USING THIS APPLIANCEIN

This appliance must be installed on 1/8” thick Commercial Grade Vinyl composition floor finishingmaterials or equivalent.Combustible side wall clearan

A stability bracket shall be secured firmly to the fabric of the building. For positioning of bracket(See Fig. 3). A safety chain should also be ancho

The maximum gas inlet pressure to the appliance must not exceed 10” w.g. for NG and 14” forL.P. Gas. The minimum gas inlet pressure at the appliance m

INSTALLATION/LEVELLINGThe 6-4 Series is designed to stand on a flat and level surface, however, any unevenness maybe overcome by adjusting the four le

HOTPLATE CASTINGS1. Attach earth cable from centre casting to cooker chassis and locate over burner bodies. Repeat for LH and RH castings and that the

4. Position burner caps onto burner bodies. (See Figs. 7A, 7B & 7C)15Fig. 6C DESN 512419 A3. Fit and secure six burner rings using M4 screws on re

Fig. 7C DESN 511617FITTING BURNER CAP - RAPID AND SEMI-RAPID BURNERSBURNER CAPRETAINING LUGS16Fig. 7B DESN 511618BURNER CAPASSEMBLY OF RAPID AND SEMI-

5. Fit the pan supports in the following order The pan supports are marked on the underside tocorrespond to the markings below. The pan supports must

1. Locate tabs on rear of splashback assembly, into the brackets on the upper rear of the cooker. (See Fig. 9).Push fully into place.Fig. 9DESN 512394

UsersGuide19

SECTION PAGEINSTALLATION SECTION 3TECHNICAL DATA 4INSTALLATION 5FITTING AND PRODUCT DIMENSIONS 6ELECTRICAL CONNECTION 7 - 8CONNECTING TO GAS 9LOCATION

20GENERAL INFORMATIONAs responsible manufacturers we take care to make sure that our products are designed andconstructed to meet the required safety

1. Do not store combustible materials, gasoline or other inflammable vapors and liquids neara range cooker.Child SafetyChildren MUST be taught safe ra

22Fig. 10 DESN 512646 B

o The GAS HOTPLATE CONTROL KNOBS can only be rotated counter-clockwise from theOFF position.Symbol - Ignition SettingLarge Flame Symbol - High Setting

zThe hotplate has six gas burners:front left - ultra rapid (wok) burner - rated at 4.5 kWrear left and front centre - semi-rapid burners - each rated

IMPORTANT SAFETY CONSIDERATIONSzSimmering aids such as asbestos or mesh mats are not recommended. They can impedeburner performance, damage the pan su

TO FIT PAN SUPPORTSFit the pan supports in the following order. The pan supports are marked on the underside tocorrespond to the markings below. The p

SETTING UP THE COOKER FOR USEBefore you can use the lower left hand oven of the appliance it will be necessary to set the ‘timeof day’ clock.This is a

THE SIMMERING OVENThis is used for long, slow cooking over 6-8 hours, keeping food warm and warming plates forshort periods.EXTRA CARE MUST BE TAKEN W

IDEAS FOR THE SIMMERING OVENMany favorite recipes can be adapted for this type of cooking. Check that chosen ovenware will fit into the oven.Meal 16 -

InstallationSection3Remember, when replacing a part on this appliance, use only spare parts that you can beassured conform to the safety and performan

Meal 2 6 - 8 hours cookingRoast Fillet of LambDauphinoise PotatoesBread and Butter PuddingRecipesRoast fillet of Lamb900g - 1.25 kg (2-2 1/2 lbs) lamb

Meal 3 6 - 8 hours cookingHam and Apricot PieBraised Red CabbageSt. Clements PuddingRecipesGammon and Apricot Pie2 ham slices approx 15mm (1/2”) thick

Meal 4Chilli Con CarneFrangipane and Apple PuddingRecipesChilli Con Carne450g (1lb) minced beef 1. Brown the minced beef in a flame proof casserole di

BROILING OVEN zTHE BROILING COMPARTMENT DOOR MUST BE KEPT OPEN WHEN THE BROILERIS ON.zCAUTION: Accessible parts may be hot when the broiler is in use.

GeneralzThe ovens and broiler compartment are fitted with side and back self-cleaning panels. Theroof of the oven is also self-cleaning enamel.zThe sh

Cooking HintszShelf positions are counted from the bottom.zPut dishes in the centre of the shelf.zWhen using the fan oven, reduce conventional oven se

zThe right hand upper oven is a conventional oven which means that the heating elements are in the top and underthe base of the oven compartment.zThe

37APPROXIMATE COOKING TIMEFOOD SETTING °FSHELFPOSITION45 mins275 - 300 1 or 2212 or 31 or 2332 or 3331 or 2111 or 22 or 32 or 32 or 32 or 32 or 32 or

Whole Fish e.g. trout, mackerelSteaksOven-fried fishSalmon (2.7kg)Meat & PoultryBeefLambPorkChickenTurkeyDuck & Goose CasserolePuddingsMilk Pu

• Baking Oven • Baking Oven • Baking Oven • Baking Oven • Baking Oven • Baking Oven • Baking Oven FOOD SETTING °FAPPROXIMATE COOKING TIMEMeringue Topp

HOTPLATENATURAL GAS L.H.F. R.H.F. R.H.R. L.H.R. CENTRE CENTREWOK FRONT REARBURNER TYPE ULTRA-RAPID RAPID RAPID SEMI-RAPID SEMI-RAPID ULTRA-RAPIDMAXIM

The minute timer works separately from the time of day clock and can be set to time periods from1 minute to 23.59 hours. Only a one handed operation i

This can be used to set an automatic cooking program in the Baking Oven only. It switches theelectricity on and off at the pre-set times.The maximum l

KEYLOCKIf this mode is activated, a program can be set, but it will not be function, ie. ON and OFF timeswill be set, but the timer will not switch th

COOKER PART AND FINISHVitreous EnamelBroiling - base onlyHotplateControl panelPan supportsRoasting tinBroiling panRoasting, simmering & fan oven -

COOKER PART AND FINISHSelf-Clean EnamelRoasting and baking oven, sides, roof &back panelsSimmering oven - sides & back panelBroiling compartme

Oven Shelves - These shelves are designed to slide outBroiler Shelf - operates as oven shelvesSTOP ON SHELFMUST PROJECTUPWARDSSHELF STOP AND ANTI-TILT

46ASSEMBLY OF RAPID AND SEMI-RAPID BURNERFITTING BURNER CAP - RAPID AND SEMI-RAPIDBURNERBURNER CAPBURNER HEADELECTRODEBURNER CAPRETAINING LUGSDESN 511

47DESN 513512Fig. 20WOK BURNERDESN 513714Fig. 20 AULTRA RAPID BURNER

ServicingSectionRemember, when replacing a part on this appliance, use only spare parts that you can beassured conform to the safety and performance s

zCOMPLETELY ISOLATE FROM ELECTRIC SUPPLY BEFORE SERVICING.zIn the event of your appliance requiring maintenance, please call Aga-Ranges Service or con

CAUTION: THIS INSTALLATION MUST CONFORM WITH LOCAL CODES OR, IN THEABSENCE OF LOCAL CODES WITH THE NATIONAL FUEL GAS CODE, ANSI Z223.I/NFPA54 AND NATI

50Fig. 23 DESN 512393 CFig. 22 DESN 512935 AWARNINING: WHEN SERVICING OR REPLACING GAS CARRYING COMPONENTS,DISCONNECT GAS SUPPLY TO APPLIANCE AND AFTE

51Fig. 25 DESN 512400 AFig. 24 DESN 512407 BB. TO REMOVE SIDE PANELS1. Isolate from electric supply.2. Proceed as ‘TO REMOVE HOTPLATE CASTINGS’.3. Low

D. TO REMOVE HANDRAIL (SEE FIG. 25)1. Loosen 2 grub screws, one at each end of hand rail (see fig. 25) using 3/32” socket key.2. Slide handrail forwar

E. TO REMOVE GAS TAPS/IGNITION SWITCHES1. Isolate from electric and gas supply.2. Proceed as ‘TO REMOVE HOTPLATE.3. Proceed as ‘TO REMOVE FACIA’.4. Di

F. TO REMOVE GRILL REGULATOR1. Isolate from electric supply.2. Proceed as ‘TO REMOVE FACIA CASTINGS’.3. Remove two screws securing control to control

I. TO REMOVE ELECTRODES (LHR, CF, CR, RHR, RHF BURNERS)1. Isolate from electric supply.2. Proceed as ‘TO REMOVE THE HOTPLATE’.3. Proceed as ‘TO REMOVE

K. TO REMOVE THERMOCOUPLE (LHF BURNER)1. Isolate from electric supply.2. Proceed as ‘TO REMOVE THE HOTPLATE’.3. Undo the nut fixing the thermcouple in

L. TO REMOVE THERMOCOUPLE (LHR, RHR, RHF BURNERS)1. Isolate from electric supply.2. Proceed as ‘TO REMOVE THE HOTPLATE’.3. Undo the nut fixing the the

N. TO REMOVE ELEMENTS (RH OVENS)1. Isolate from electrical supply.2. Proceed as TO REMOVE OVEN AND BROILER LINERS’.3. Remove oven base panel (1) screw

59

FITTING AND PRODUCT DIMENSIONS6Fig. 1DESN 512636 CAny side wall above the cooker on either side shall be not less than 3” (75mm) horizontally fromthe

60For further advice or information contact yourlocal Aga distributorWith Aga’s policy of continuous productimprovement, the Company reserves the righ

Electric Shock HazardElectrical Grounding is required on this appliance.Do Not connect to the electrical supply until the appliance is permanently gro

ELECTRICAL CONNECTION IS LOCATED AT THE TOP RIGHT HAND SIDE OF THEAPPLIANCE, BEHIND SIDE PANEL. DURING INSTALLATION REMOVE THE RIGHT HANDSIDE PANEL TO

WIRING DIAGRAM 59CAUTION: ENSURE THAT THE COOKER IS ISOLATED FROM ELECTRIC SUPPLYThe cooker can be installed with an approved flexible connection. Sup